Very nice. Did you fit the nut in during or post?
I see you have the Flexion extruders on in that pic - is it an older one?
Type: Posts; User: lehighkid
Very nice. Did you fit the nut in during or post?
I see you have the Flexion extruders on in that pic - is it an older one?
I print via OctoPrint (on an RPi3) web interface from my MacMini. I have S3D on the MacMini set to automatically upload gcode when the slicing file is saved. I have yet to print from an SD card.
Good to know - I would prefer not to wrap them if I can get away with it. It's a PIA.
Oooooh - I like that, I like that a lot! Do you still wrap them w/ insulation & Kaplan tape or are they good to go as is?
Sorry, no - not recalibrate the thermocoupler, recalibrate the blocks and height when I run the the new thermocoupler into the heat block because I don't think I will be able to do it while it on the...
I know DaveB has seen this but have the rest of you seen the FlashForge Creator Pro Turbo video with all the upgrades he did on Thingiverse? http://www.thingiverse.com/thing:1681920
I especially...
W - I got the Flexion extruders and took a bit to dial in but now I have the printing near flawlessly w/ ABS, PLA and NinjaFlex (what I really wanted them for). What were you unable to refine? The...
W - I'm not sure if you saw it on Flexion's site, but they provide a filament guide tube adapter that fits nicely on the Qidi. It's available here:...
This is a file for machines that do not have load /unload filament scripts on the printer like ours.
BTW. I got and installed the flexion too. I am only using the right one while I wait for a new...
I've been stalking this thread since I got my Qidi a few months ago and just recently had apparently fried my mainboard. Qidi support was awesome and diagnosed and sent me replacement parts that I...
I've tried both but typically use the one on the machine because I keep it hooked up to Octoprint.
MODERATOR NOTE: Post is late to appear due to unexpected problems obtaining moderator approval.