Search:

http://www.aliexpress.com/item/Anycubic-LCD-Diy-3D-Printer-Kit-Large-Printing-Size-Kossel-Linear-Guide-Rail-Delta-1kg-1/32572584498.html?spm=2114.01010208.3.43.AT171v&ws_ab_test=searchweb201556_1,sear...

no real complaints being cheap i have needed to order a heated bed and some additional parts to make it more useful pla is fine but without heat others are a issue. I picked up a used Da Vinci 1.0...

http://www.ebay.com/itm/PLA-filament-for-3D-printer-only-5-spool-10-colors-Box-/222030364322?hash=item33b20a7ea2:g:zj0AAOSwNSxVbfk0
I have used this company ABS materials and just purchased another...

I have this delta kit basically, mine is orange and didnt have a heated bed, that i purchased from aliexpress I think it is a decent item i wouldnt buy or pay this much tho.

http://www.aliexpress.com/item/Autom...e-0b3923afc152

i built this one and have been pretty happy! learned alot during assembly and configure

I am happy with the delta kossel printer. i have had a few with setup of the machine as i have never had a 3d printer or even used one before. I have learned alot and was not overly difficult. i have...

I use HFT blue painters tape and the elmers purple to clear glue stick and havnt had a relase since this combo unless the z home is wrong and your too far way from the bed.

http://www.aliexpress.com/item/Automatic-Desktop-3d-printer-large/32261046955.html?spm=2114.01010208.3.1.E9jXPP&ws_ab_test=searchweb201556_2,searchweb201644_5_505_506_503_504_502_10014_10001_10002_100...

how mechanically inclined and good and following directions?, Buy a kit and assemble.

So i have just finished a delta and like the height i can print thinking i would like to build something with more size in width maybe overall if i custom build a larger one. Ideas or suggestions?...

Thanks I understand now.

For my learning and understanding i would like to figure out why / what i did that was causing it to not work correctly. This is my first printer but for sure not my last, as i will be probably going...

luckyimperial, actually was late getting back here after trying Cura, all works fine. Not sure why even the sd card would give problems, it is possible the settings wither pronterface are wrong but...

i dont think the print i have is small especially the test box is quite small. just no matter what i print from pronterface or the sd the machine goes striaght for the edge of the machine and shoves...

Please any help would be great This is my first 3d printer but have been around computers and electronics since i has a kid pre 1990. I am not a total idiot but as i get older things take a time to...

I am working on the calibration just got the numbers for bed with paper thickness but when I tried a text cube the other day the head went outside the frame and straight down and was grinding on the...

lucky imperial as you seem to know about these also i have i belive the same printer as the op and i am at the point of calibration and wondered if you would have any help/leads? i have been in...

If you have not figured it out yet you have the pivot / extruder mounted up side down the nub goes up and a limit switch mounts to it.