You've probably blown the FET closest to the heat plate terminal on the driver board. It has happened to an number of people, including me. See the circle in the picture below. If you are lucky,...
Type: Posts; User: RussBean
You've probably blown the FET closest to the heat plate terminal on the driver board. It has happened to an number of people, including me. See the circle in the picture below. If you are lucky,...
I have determined that the Core Board is bad, and the Driver Board suffered a fused FET during the troubleshooting process. Rather than replace both boards I'm parting out his 3D printer in the...
I'm parting out a FlashForge Dreamer that I picked up for salvage. Due to my not wanting to invest in a new core board and driver board, I'm selling the pieces to recover my initial investment. PM...
Yep, I feel like a fool. I had each of them off by one.
I'm using FlashPrint, so I believe it should be outputting compatible g-code. I too believe it may be a corrupted firmware issue, but until this morning, I was unable to change the firmware. Last...
Thank you for the suggestion. I have posted to the group here.
The result is the same when printing from SD card or USB. It goes through warmup then hangs. I'm going to try manually reinstalling the firmware; if that doesn't work, I'll monitor the voltage on...
I'm having trouble with a FF Dreamer. It powers on. I can control all steppers manually. It will home just fine. I can control the printer via USB. It will heat to appropriate temperatures, and...