So that confirmed what i was expecting. There was something wrong with that specific version or the way i configured it because the bugfix version worked flawlessly.
Type: Posts; User: iineviitable
So that confirmed what i was expecting. There was something wrong with that specific version or the way i configured it because the bugfix version worked flawlessly.
Updating to it now, sorry for the weirdly spaced responses, i work really weird hours.
I thought of that aswell but i turned the acceleration down to less than 1000 and it didn't seem to help, i may have done it wrong though.
Just tested and everything moves perfectly in the center. M119 reports as open on all 3 but the extruder still only feeds for 1mm at a time from the lcd and not at all from repetier host, matter...
I said pronterface. I can move it 1mm at a time from the lcd. version 1.1rc7. lcd is reprap discount full graphic smart controller
I've done all that, i can't get it to move further than 1mm at a time in marlin. But in repetier its perfect.
So in marlin my extruder won't move but in repetier it moves perfectly.
It isn't a temp issue, i have it at 200C while trying to move it.
If i move it in marlin by 1mm it moves but if i move it by...
I thought about all that and it seems as though the input is damaged, i swapped the connector for the bed's thermistor and it reads at -12 when i put it in the hot end's thermistor. I brought the...
I updated my I3 to repetier from the anet firmware that came with it and everything was working fine until I ended up shorting out my thermistor.
I replaced my thermistor and the reading was about...