Close



Dig deeper, search our News website




Search:

Type: Posts; User: PlastiTech

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    5,936

    Do you have Linear Advance and S-Curve...

    Do you have Linear Advance and S-Curve Acceleration both enabled in the firmware?

    I had an issue with really rough bow surfaces on the Benchy while using Linear Advance. Disabling S-Curve...
  2. Thread: Slight Gaps

    by PlastiTech
    Replies
    6
    Views
    3,994

    It looks like you may need to calibrate your...

    It looks like you may need to calibrate your extruder steps (e-steps) and/or adjust your flow rate. I'm thinking you have a problem with under-extrusion.
  3. Replies
    4
    Views
    2,947

    I think you either need to bring the nozzle...

    I think you either need to bring the nozzle closer to the bed, raise the bed temperature or lower the first layer speed.
  4. Replies
    14
    Views
    10,488

    You're welcome. I hope this completely solves the...

    You're welcome. I hope this completely solves the problem.

    185 on the nozzle is on the really low side, but if it works for you, great!
  5. Replies
    14
    Views
    10,488

    My guesses are that you either have a problem...

    My guesses are that you either have a problem with heat creep, or the PTFE tube is not flat against the heater block, or the nozzle itself needs to be replaced.

    Heat creep occurs when heat from...
Results 1 to 5 of 6