On an ender 3 with octoprint. Running an older marlin.
Type: Posts; User: Gomja
On an ender 3 with octoprint. Running an older marlin.
I can pid tune my hotend and it completes successfully. I enter the values with m301 command and then try to heat up my hotend and it halts due to temp error at 235 of 245 degrees. I can run the...
Ive been reading about esun petg configuration. They want you to do a z offset calibration. Currently I dont see that option in Cura anywhere. But I have been setting the Bed Z in the octoprint...
I figured it out. I had the nozzle set incorrectly in cura. Fixed that and im back to printing normally.
I really wanna be able to print in Petg. At first it seemed like this filament from Inland might work. It was just really prone to getting everywhere. Now after a couple days it wont even stick to...
nvm found a guide that shows how to use it. Thx
solved. See "First print ever...what happened here"
Thanks! this fixed about 90% of my problems :D One quick question...does Bed Z:
a) do nothing
b) raise bed (so positive values bring the bed closer to the extruder)
c) raise extruder...
I set this up in the marlin firmware to compensate for a very uneven bed. But it doesnt seem to work. I adjust it and it has no squish. I try the Bed Z: increase and that also doesnt seem to do...
Ok I figured out the problem. I enabled mesh bed leveling in the marlin firmware to correct VERY uneven print surface between the front and back of the bed. But the mesh leveling doesnt seem to...
I ordered a glass bed. Im thinking im not close enough to the bed to get a good squish with the default soft bed. Ill try the options you suggested also. Profile is attached if you are curious.
Printed a test cube at .04 and 30 speed. Same problem. Perfect walls and sides but terrible bottom.
13290
Also its an Ender 3. Should I try printing it slower and maybe at .08?
Layer height was .16 and 60 speed. I turned on supports in cura (or atleast I thought I did). But when I first imported the stl into cura I did flip it to having the face that printed poorly to be...
This is my first ever non bed leveling print. The the side facing the bed is terrible. But the walls and tops are very nice. Here are the pics. (PLA at 210 with 60 bed temp)
13283
13284