That's a good thought. I switched to a different printer for the one that was clogging with many supports, but next time I run into the same problem, I'm going to try slowing down the supports and...
Type: Posts; User: verersatz
That's a good thought. I switched to a different printer for the one that was clogging with many supports, but next time I run into the same problem, I'm going to try slowing down the supports and...
Update on this: I was finally able to unclog it and put the extruder assembly back together. It's working for the most part. Some prints are fine, some have been clogging repeatedly with no clear...
I normally print PLA at 210 when it's actually printing. I was just using the default preheat settings for clearing the nozzle so I could melt the clogged stuff enough to get it out.
I'm printing with PLA 1.75mm. The nozzle is at 230 C, which is Makerbot's default for preheating. I heated it to 250 C at some point when trying to unclog. At this point, there's no printing speed,...
Here's the short version of the problem I'm running into:
Printer started partially extruding in the middle of a print, so I stopped it. Tried to unclog. No matter what I tried, it either...