Search:

Hi!

I was about to remove the resistor R29 so that I can get accurate temperatures with the V6 but it looks like there is nothing there? It's a white dot. I'm looking at the bottom of the board...

It didn't do it when I was using ABS.

It's because of heat creeping up the barrel and melting the PLA prematurely which causes it to swell and inevitably block the tube.

I've officially switched to PLA.

I've added a small heatsink to the threaded rod on the extruder, sometimes it works and others not.

Today I got it to print one thing and even then it was...

The settings I have at the moment are the standard for Slic3r. What do I need to adjust and to what extent? Does one need to be adjusted if another value is changed?

Permimeters: 60mm/s
Small...

Da Vinci 1.0A with a 200x200mm bed

I'l leave honest feedback and I wont waste your time, I'm appreciative of these opportunities to help others.

Da Vinci by XYZPrinting. Large heated bed and build space, enclosure, flash it!

It finished a while ago and upon inspection it is a bit better, i measured the diameter of the filament at it was 1.8mm so I put that into Slic3r settings. I used the red ABS from PrintME3D this...

Ok, I'm about to have a go at printing a case for my sisters phone so I'l let you know how it goes in an hour or so.

Ah ok, would that mean a small number or a big number?

I'm new to the 3D printing scene

Thank you all for your responses, I'l try them later.

I've just tried printing PLA and it seems to get to around 2 minutes in and it makes a clicking sound and the filament stops getting extruded...

Any help would be great, it's driving me insane -_-

Hi,


I'm new to 3d printing and I have stumbled accross some problems that I cant seem to get my head around.


Just incase it's needed, I have the Da Vinci 1.0A with Repetier 0.92. I use...