After some further investigation, it looks like this might be a linear ball bearing wrapped in a bit of plastic, and I might be able to make do with a couple of worm gear clamps around the plastic to...
Type: Posts; User: logic
After some further investigation, it looks like this might be a linear ball bearing wrapped in a bit of plastic, and I might be able to make do with a couple of worm gear clamps around the plastic to...
After much Googling, I haven't found much but I did find this:
https://www.ebay.com/itm/1x-LMH6LUU-Metric-8-5mm-Inner-Dia-Oval-Flanged-Long-Linear-Bearing-/264508028984
The guide rods do seem...
Sigh.
My printer was built from a kit (TRONXY X5ST-400), and I can't find a parts list anywhere. I managed to break something important, but I don't know what it's called in order to search for &...
A 300x300 silicon pad stuck to the bottom of the 400x400 aluminum print bed (which has an integrated 12/24VDC heating circuit that I'm not using) seems to be working quite well. The heat takes a...
Thanks for your reply :-) I'll proceed then with a 300x300 heater on the 400x400 aluminum plate, and I'll give an update once I know how it's going. :-)
I have a TRONXY X5ST-400 that I built from a kit. When I first powered it on, the control board immediately exploded, so I have been working on reworking it to use an SKR 1.3. Unfortunately, it...