So I recently decided to try to print with a smaller nozzle diameter but I have run into a problem.
The filament extrudes somewhat out of the nozzle but after each extrusion step, there is a small...
Type: Posts; User: orm255
So I recently decided to try to print with a smaller nozzle diameter but I have run into a problem.
The filament extrudes somewhat out of the nozzle but after each extrusion step, there is a small...
I seem to have forgotten to change it to 0.4 after setting extrusion width to manual. It was set to automatic at 0.4mm which automatically changed the nozzle diameter 0.38 for some reason.
Also, I...
The current settings for retractions are:
Distance: 2.00 mm
Extra Distance: 0.00 mm
Vertical Lift: 0.00 mm
Speed: 30.00 mm/s
The starting position was set to optimize for...
I tried a few more prints and I may have found the culprit.
It may have been retraction vertical lift as after disabling this setting, the print had almost no stringing at all.
I have reduced the...
Ok, here are some pictures.
http://imgur.com/a/5x6Lz
Hi everyone!
I am new to this forum so please let me know if i posted this in the right section.
I have run into a problem with my Duplicator i3 using Simplify3d.
I have read about the retraction...