okay let's look and the G code produced by both softwares now it seems the movements are the part of the code that does not function in prusha primarily they both use G1 commands for this this is of...
Type: Posts; User: don't
okay let's look and the G code produced by both softwares now it seems the movements are the part of the code that does not function in prusha primarily they both use G1 commands for this this is of...
it wont let me edit my last post ya know I do not think i added the printhead settings maybe this is it not sure what the equivalent of those are
edit well I didn't find those but I did set the z...
okay well I tried replacing the existing start and end g-code with what was found in Cura and resulted in no change, it just goes to the corner of the bed and extrudes plastic until it buries the...
I tried asking this on a different form that turned out to be dead at closer inspection so one more time over hereOkay i picked up one of these printers for $50 the easythreed k7, after some fiddling...