In a Zero g environment, why do you need any sort of support at all?
Type: Posts; User: lithgowlights
In a Zero g environment, why do you need any sort of support at all?
When I had a similar issue on the Dreamer it tuned out to be the small tube between the extruder head and the filament drive motor. This small Teflon tube looked ok, but must have had a buildup...
When it does the test line along the front to clear the extruder, is it printing that parallel to the front of the bed, or at an angle back (or forward)? If it's at an angle the answer is the print...
On my Flashforge Dreamer the layer start point leaves a little thick bulge of plastic for maybe 1/2mm long and probably 0.1mm thick - about half again as wide as the nozzle is laying down. For most...
I have an odd problem. I am running a Flashforge Dreamer with buildtak sheet on the bed, and things, mostly ABS, are sticking too well onto the bed, making them really really hard to get off. I am...
90% of my 3D prints will end up outside for 6-7 weeks a year, and in the Australian summer the UV levels are not exactly low, so I don't think PLA is exactly the right choice for me. Plus I want some...