i think that tronxy x5sa pro came with restricted firmware chitu that need to be changed... the ptfe tube in the bowden make same tricks of few millimeters that make bad retraction print. need to be...
Type: Posts; User: shakle
i think that tronxy x5sa pro came with restricted firmware chitu that need to be changed... the ptfe tube in the bowden make same tricks of few millimeters that make bad retraction print. need to be...
It's the same mod. What have I buy on aliexpress to make this mod?
What product is it?Where can i buy it?
can you recommend some links of some direct extruder that takes up little space?
i have the tronxy x5sa pro stock... i want to add direct extruder without take any print volume (not even a millimeter ;p) i see many project on thingiverse. what is the best?
Hi, I would like to know if you know any direct extruder mods that don't steal print volume..Can you recommend some links to buy?
i tried many temperatures. but the wires on the retraction test printed remains. I can't fix this problem.. the settings in Cura are correctedit: i found this M8020 S0M8033 S0M8500 to enable...
she had probably saved him then. however I created a gcode with the m301 and m8500 command and I sent it to print .. now the temperature seems to have improved .. the variations remain +/- 2 now. I...
The fb page is a null page. I tried with M8500 but after a series of error printer beeps..............................................step_num 990010 > 0xffff#########E 509 Error!!!step_num 993904 >...
ok. M8500 not M500.. Are other commands unchanged?
i'm using Chitu stock firmware.. Maybe that is Marlin better?this is retraction test... very bad
hi, i made pid tuning for the extruder
SENDING:M303 E0 S200 C8
// bias:108 d:108 Ku: 21.402323 Tu:36.000000
// Kp: 12.841393 Ki:0.713411 Kd:57.786270
// bias:108 d:108 Ku: 20.993881 ...
I added lines in the extruder section start gcode of Cura. the code does just that.. prints a line at the edges of the plate before printing. Does this problem only occur on the Tronxy?
Hi, with my tronxy x5sa pro i have some problem when I start first layer. Before print first layer the nozzle spits some PLA dirtying the first layer and consequently the whole print. To overcome...
fixed the problem. The extruder axis was obviously bent. the distance of the two extremes were different.
found the problem.. the axis of extruder is crocked... does it have a verse?
https://imgur.com/Ad9cArs and https://imgur.com/14O5LkM . What is wrong?
I was successful in the calibration. Now the problem is that the shapes are bad. The squares are then flattened into a rhombus shape..
fixed the problem! a few screws had entered the pulley... at the first calibration there were some clicks on the axes but now the plate has arrived on top .. what should I do? it's my first...
the motor axes turn, doesn't cause chattering noise...the bed is parallel with the frame..but doesn't move when motor runs
Hi, the two Z motors run without without turning the axis bars. I tried to tighten the screws but don't block the axis. How can i fix?
I don't know. I was wondering for this. I would like to get the best one if there is and obviously upgradeable to marlin..
xxxxxxxxxx
convinced that the sapphire 1.1 cost almost as much as the tronxy,instead was version 1.0. at this point more than decided for the tronxy x5sa pro. Which mainboard should I take? the manufacturer...
From what i read sapphire is faster than twice as fast in printing. It's true? How much print quality do the two differ?