Hello all
I just cannot find the wiring diagram (that I can trust) for the filament detection connection.
I believe it plugs into X Min. Its a 4 pin socket, but does anyone know the...
Type: Posts; User: Stevolution2019
Hello all
I just cannot find the wiring diagram (that I can trust) for the filament detection connection.
I believe it plugs into X Min. Its a 4 pin socket, but does anyone know the...
Hey all
My Flashforge creator Pro has been bulletproof for a couple of years now.
Then it started to fail. Prints not sticking, clogged nozzles etc.
Are they discontinuing this printer? ...
It was a combination. The roller wheel is worn (has a groove around it). But also the actu
al extruder mechanism was not keeping up the pressure between the wheel and the geared cog - so it was...
OK.
After a *#*$ load of searching...
I have sourced the correct drive gear for the stock extruder (Pic attached). Fits the stock extruder drive perfectly.
But, also sourced the entire plastic...
Nozzle jammed this morning. 20 mins with a blowtorch and just cannot get it unblocked. This was a new nozzle+PTFE tube 1 week ago.
I have come to the conclusion that the Creator Pro is basically...
Hi
I am printing a whole load of parts in PETG.
All started well, then the right hand extruder started playing up and now doesn't work...
OK, over to the very little used left hand extruder...
I have to be honest, this damn machine is starting to get on my nerves!
It has started 'clicking' and after investigation, the left hand feed roller was worn.
So I swapped it with the right hand...
Hello all
My lovely Flashforge Creator has started to be a problem child....
Right hand heater element, or thermistor is playing up. Can't find a single heater block + Thermistor anywhere in...