I ended up fixing this problem by replacing the board. I also added a MOSFET for the bed. So it appears that the issue was a defective board. What was wrong with the board? I couldn't tell you. But...
Type: Posts; User: Demxsr
I ended up fixing this problem by replacing the board. I also added a MOSFET for the bed. So it appears that the issue was a defective board. What was wrong with the board? I couldn't tell you. But...
The popping can sometimes be caused by the filament collecting moisture if it is not stored in a sealed package with a packet of desiccant. If this is the case, it could add to reduced print quality....
I'm printing with PETG, using Cura, at speeds of 40m/s or below, bed at 83C, and nozzle at 230C. I don't have this issue with PLA, just PETG. The first layer that prints on top of the Infill is very...
everything is barely warm to the touch. I have heatsyncs on all the drivers with a fan blowing directly across them. Motors are not warm either during prints.
The "consistency" of the inconsistent filament flow might point to extruder. Maybe a worn down toothed gear, spring tension is a bit too loose, or motor shaft is bent or something is causing it to...
It could totally be a problem with the firmware, I compiled it myself. Its a hypercube evolution that was a complete DIY build. The failure occurs about 40% of the time on prints longer than 5 hours....
The main issue is the X or Y motor stopping randomly during the print and not starting up again. Or both stopping at the same time before the print is finished. In the first picture 1 motor stops,...
I built a Corexy machine. It's running a SKR 1.3 with TMC2208 in UART and marlin 2.0 bugfix.I've had multiple successful prints. But I've also had this issue with where either the X or Y motor just...