Ok I think I have found the cause and its an odd one, so I thought I would post it in case anyone else comes up against this in the future. I opened the motherboard cover to check if any connections...
Type: Posts; User: MrSpan
Ok I think I have found the cause and its an odd one, so I thought I would post it in case anyone else comes up against this in the future. I opened the motherboard cover to check if any connections...
After an aborted BLtouch upgrade I decided to return to a tried and trusted FW. I had saved it for such an event and uploaded to the Ender 3V2.I enabled pre-heat and went about manual levelling....
Fitted a BL touch to my Ender 3 V2 using Youtube vids, modded source code to enable Touch etc. However when I select "Level" from the printer display the print head does the following.Moves to @XY 0...
I took Gambos advice and increased the fan airflow onto the main board. Actually I tweaked the regulator voltage a bit. Its a 5V fan but I increased the reg to 6V. I guess it may fail sooner with...
Thanks I hadn't really considered that. I upgraded all fans with quieter ones as the first upgrades I did months back. But when the faults happened I was driving everything at full tilt doing 100%...
I have had my Ender 3 V2 for a a few months. Done the normal quiet fan mods, upgraded the extruder to a Titan clone 3:1 geared, and then updated the FW to Marlin 2.0 +bugfixes as I had to increase...