I was currently using Matter Control even though I think I have most major slicers installed. I did not try another as I am under the impression it is a mechanical issue (see my last post as it...
Type: Posts; User: protechtrader
I was currently using Matter Control even though I think I have most major slicers installed. I did not try another as I am under the impression it is a mechanical issue (see my last post as it...
It is from top to bottom on the one side.
I think it is mechanical as even though there wasn't any intentional changes I had the belts off as I cleaned out the printer, the bars and extruder. I...
Hello,
Somehow I started getting this large scar/cavern in my prints and I wanted to ask what the possible causes are of something like this. The picture below is of a 20mm cube showing the scar...
Hey all,
I wanted to see if any of you could identify the possible cause of this print getting more rough (it wasnt great to begin with I know) part of the way up? I used a 50x pocket microscope...
Hello,
I am having trouble finding the proper assembly instructions for my MK8 Extruder Hot End Assembly. I have read sources recommending threading nozzle by hand, then backing out a turn and...
Unfortunately not. I determined it was a issue being created when gcode was translated to x3g with the heated bed temp gcode. I think I found the line with the issue, just need to do another test.
Somewhere I must have changed something on my printer (Replicator Clone) causing a odd pattern of spiraling/diagonal lines on perimeter walls in all of my last prints. It has happened last 3 prints...
Thanks for the reply! Based on that I am leaning to think that its more about printed material size and a bit less about quality & strength of object when comparing some of these $500 range units to...
Hello All,
I have read so many reviews and guides and watched videos and I am still having trouble deciding a model 3d printer to buy so I wanted to ask a community. I am a very tech savvy...