I might not sure of the tube size.
On Amazon I ordered an entire new unit like this, that way I have all the parts I need. Lots of parts for the money here....
Type: Posts; User: Rover31
I might not sure of the tube size.
On Amazon I ordered an entire new unit like this, that way I have all the parts I need. Lots of parts for the money here....
I would love to see comments on these. If I could add folks that have any of these do you like it or not?
I have a CTC 4880 that I purchased second hand. It is a cheap one and obviously has low...
I did try new wires and it had no effect. mine is doing this on start up so not a heat issue for me.
I do know that it is the mother board or stepper driver. I have new drivers on the way will...
More updates
looks like either the motherboard or the stepper drivers are bad.
Argh!
I went all out,
new nozzle still clicks, fine... so I got a new extruder it clicks also and doesn't extrude. I can push filament through by hand and it works, not on its own though, just...
Using PLA as for settings will have to check. I am assuming you want temp and speed?
That is one of my issues as a new guy and not having a manual for this unit, what the heck are they supposed to...
Thanks for the reply, yes more info is always better.
The nozzle heats up, when it heats up I can push filament through. I did take it apart and the feed wheel is clean no filament needs to be...
Hello new guy here that was really learning a bunch until my extruder I think died.
i have a ctc d4880 one of the eBay cheapos.
it had been working very well until out of the blue it stopped...