Question about bed leveling. Most instructional video's I have found on Youtube or vendor sites inidicate the use
of a piece of typing paper for "feeler gauge" to determine correct standoff between...
Type: Posts; User: woodrat
Question about bed leveling. Most instructional video's I have found on Youtube or vendor sites inidicate the use
of a piece of typing paper for "feeler gauge" to determine correct standoff between...
Hooray...Finally some degree of success with this little beastie..printed these on creator at 1500mm/min 205/68 PLA and muffin fan gently blowing thru printer from side onto
print. A little...
ok...again thx. tomorrow I will host a muffin fan on front opening that will target the print. I have a couple that have directional nozzles with
rheostat to control air flow. I totally agree that...
Yes I am using PLA, and there is not an extra cooling fan beside the two that exist for each extruder. Would an additional fan target the print or extruder tips.
Will try the slower speed, but hate...
New to this technology and so far not having much consistent success. I have printed several
small blocks(one to two inches in length, and half that wide, usually ¼ to 3/8 inch thick with
both...