what result does that fan serve?
Type: Posts; User: printrboy
what result does that fan serve?
Which fan? The extruder only has two fans, one cooling the filament as it goes in the barrel and another one in the back of the extruder cooling the extruder motor. Both are always on.
I will try the brim. Though it bends quite a bit so I'll need to use a brim so large I won't be able to print bigger than 8x8cm model on my 18x18cm bed, or less.
ABS.
Is getting PLA to warp this much possible?
guys? any other info i should give?
Which abs pellets are used by extruders for making filament for 3d printers?
I got few kg from a factory which uses ABS for injection molding.
Can that be used?
Or is ABS used in 3d printers...
Oh, right. It's a Solidoodle 4. I reflashed with what I think I was told is the official firmware. ...
This is hard to tell as I was only printing 1 layer test prints for calibrating my printer when I reflashed the firmware, and those don't warp. So I don't know if the warping started happening...
I've recently been getting extreme warping on everything Ive printed, small to large, edge of the bed or middle.
Maybe it has something to do with me reflashing the firmware recently.
I'm running...
That's odd, some other users seem to have it in their printers. http://www.soliforum.com/post/75071/#p75071
What about the one I linked to which Solidoodle uses? I'm not a programmer.
I'll try to give all the info I know. I'm not a programmer, so the answer might be obvious to some but not me.
All I know is I think this is the official repository of Marlin for Solidoodle...
I think it might have been removed, no idea how to add it back in. http://3dprintboard.com/showthread.php?9160-Non-Concentric-Circles&p=40055&viewfull=1#post40055
Just saying, the M98 and M99 command that Neil added and mentioned there got removed, it isnt there now...
Perhaps this can also be done in Slic3r?
I want to try out the "M99 Xmm Ymm Zmm Emm" g-code command and see how backlash can be reduced or eliminated via software. (Yes, I'm trying everything I can in the hardware department too).
...
How much will the powder cost?
What's the quality of the prints?
Ive posted this in several forums. Couldnt find a user with the nick 'Jetguy' anywhere.
Thanks for the suggestion.
I don't think that is the case since like I showed the older Solidoodle 3 prints properly and Solidoodle 3 and Solidoodle 4 use the same belts (...
Okay, first of all I know there's a Solidoodle section in this forum, but coming from another forum mainly aimed at Solidoodle users, I want to discuss this with everyone experienced with 3d printers...