Search:

That hexagon looks interesting - may have to get it just to be able to screw the heater and thermistor in (and not worry about it falling out without kapton tape).
Wonder if makerfarm will start...

I have to say I agree with this - a few bugs are cropping up from all the merges without prior testing of possible configurations.
It's getting a bit annoying actually.
I believe they are also...

Woohoo! Almost done:
https://www.dropbox.com/sc/aeoi401ioudmtbi/AADBlzfFxemMNRDYGDIyEa3ma

But time for some sleep.
--
Besides what is mentioned on the first post, is there anything else I need...

After a few prints with rafts and auto support (and slic3r 1.1.7), I now have the trouble parts printed out with much improved internal integrity.
Here is the part cooling double fan shroud with a...

You are dead on about slic3r 1.2.6 - I love the speed at which it slices but it is leaving no infill between the inner walls as you mentioned.
I'll go ahead and try those settings with 1.1.7.

Is...

I have been meaning to put together my IBDE for a few days now but I have to wait for two .3mm hexagon nozzles (yes, I broke one off somehow) so I am on the stock configuration as I await with...

So this is normal behavior, cool! I thought I wired something wrong.
If it bothers me too much I'll probably just rotate the model in slic3r or make that permanent change on the printer as printbus...

Hello there! Been stalking you guys for a bit but I believe I will need someones help for this one.
I was a Kickstarter backer for the Phoenix from Ez3d (they went under) that was lucky enough to...

Check the endstop itself to make sure it is not shorted.

So when you sent M119 - all your endstops were open?

I opened them side-by-side and anything that matched, just copied the value over.
Cura has an advanced (or expert) settings panel, but I do not think there is any need to change anything there....

Sounds like and endstop is being triggered. Try sending an M119.