well mine don't have any "W-XX" written on them at all.
I just use them as a client on a static IP and drag files to the card's web page to upload them.
Type: Posts; User: Mjolinor
well mine don't have any "W-XX" written on them at all.
I just use them as a client on a static IP and drag files to the card's web page to upload them.
I don't think my cards are w-03. I have had them a couple of years. They all connect fine to my router. It is unclear to me what you are trying to do without me going off and reading lots of guides....
Hmm, been checking the flashair-developers website. All the information is now on there. When I did mine there was nothing on there about station mode or anything llike that.
Interestingly there...
I just edited the config on mine. I have never used any sort of Windo$e software on mine at all.
I am not the person to ask about Windo$e, I never use it unless I am forced to.
Ultraedit will edit linux files under Wind$e.
Is notepad ++ linux compatible?
It says here: https://notepad-plus-plus.org/ Windo$e only so the end of line will be CR/LF instead of just LF.
Look at the config file in a hex editor,see if it...
I really think it should be 5 but as I say it has been a while. I have posted the links on how to do it in the forum somewhere.
Are you using a Linux editor, a Windo$e one will not do.
Are you...
APPMODE should be 5. Does your router really have an SSID of "flashair"
It's been a while since I did this so if it doesn't work after that then post back
Like I said, when you learn to use Google you are going to be embarrassed. Perhaps you are one of those unfortunates that believes everything they read on the Internet.
This is why I am attempting...
You are going to be very embarrassed when you eventually learn how to use Google.
The printer only understands X3G so whether or not you use USB or SD the printer still only understands X3G
If you use Repg to send over USB then RepG translates to X3G before it sends it. RepG is...
Whatever. Go and read some.
The printer's firmware does not understand STl files. Your slicer sends an X3G.
Sorry, I missed the bit where I was insulting. If you perceive that I was then you are mistaken. Do not make the mistake of education being insulting. Not knowing something is not a crime it is...
I'm sorry, you are so far away from understanding what I am saying that I cannot explain it to you. You need to go and read about USB , particularly the technical specifications of the protocol and...
USB is host processor controlled. In ordr to be sure that communications take place within the time slots required for successful handshaking the host computer must have lots of power or it will mist...