You wouldn't need to measure the amount of resin used just the thickness of the layer above the saline and if it's not enough, add more. If the interface wasn't moving this would actually be quite...
Type: Posts; User: amoose136
You wouldn't need to measure the amount of resin used just the thickness of the layer above the saline and if it's not enough, add more. If the interface wasn't moving this would actually be quite...
I was thinking about that and ideally I would think you would want a system to maintain the resin layer depth at the desired thickness of each layer and then have the laser intentionally cure it all...
But with a more powerful diode it should be possible to speed up the laser to the limit of the accuracy of the galvo system. There might be hard chemical/physical limits to the curing speed though so...
According the graph from the summary they should have box loads of them but not enough for everyone. According to the extracted data from the graph they have around 1200 coils but many other parts...
So I think I'm going to try and build one of these the Lego/Arduino route as a first attempt and then maybe upgrade to a dedicated solution later. What kinds of coils will do as substitutes? Are the...
Wiki and discussion.
@rylangrayston, I have a little electrical experience that might be enough to make an Arduino version. What sort of specs does the peachy board have? I.E. At what frequency are the coils driven at...