Search:

I'm planning on upgrading the Z rods on my Qidi Tech I from 8mm to 10mm. If you've done this mod - how did you go about it? What panels have to come off and in what order? Any help appreciated. ...

I use only Gino to attach it to the plate, no need for clips.

What thickness did you get? My original was 1/4" and a chunk pulled out of it when removing an ABS piece. Went to 1/8" and haven't...

I replaced the blue plastic with 1/4 boro glass stuck to the aluminum platform using nothing but a full sheet of Gino. Prints great. Problem: the glass plate has a lot more thermal mass than the...

If your John Deere bushing goes in an area that gasoline could spill on, into, etc. then I would consider nylon which is much more chemical resistant than ABS. I keep a roll of Taulman 910 in the...

I noticed the same thing after switching to 1/4" glass.

123D Design has a measuring tool that works on imported STL. It's quirky but might work for you.

I asked Makergeeks what the difference was and was told it's the same product.

Double click on the model to bring up the scaling function, it will list the current model size as XYZ.