1 Attachment(s)
XYZ Printer only printing .75-1.65 high! What has happened?
I was printing a snowman. it was split from side to side (2 halves vertically.) So the tallest spot was the big belly and the carrot nose. When the Z axis got to 17.6 MM of 37.4mm it quit! It did not gum-up, slip, or drag material. it just stopped.
I then attempted to Print the Lion_t (from Thingiverse). It was cruzing along, even printing the support material. When the Z axis went over the 1/2 inch mark, i was excited. :) When I checked a few hours later, it too had stopped. This time at 26.4 mm.:(
I am using an XYZ pr, with Slic3r to clean up and Save the Thinigiverse .STL file, then importing that into XyzWare, for the printing And to decrease the slicer time. I have Pictures.
Attachment 2487
Can anyone Help?
This is my first post...