HICTOP Prusa I3 3D - 270*200*170cm
Just got one and assembled it. Found this forum and didn't find thread for this printer so decided to make one.
Anyone else out there have it?
Hardware seems to be good, still working on adjusting it.
One issue was the y-axis limit switch did not contact anything. Built a tab out of scrap stuff that I double-sided taped to the frame so the limit switch has something to contact. Seems to work very well.
Any other problems out there?
Same problem reported on RepRap Forum.
Quote:
Originally Posted by
MunchMunch
Just got one and assembled it. Found this forum and didn't find thread for this printer so decided to make one.
Anyone else out there have it?
Hardware seems to be good, still working on adjusting it.
One issue was the y-axis limit switch did not contact anything. Built a tab out of scrap stuff that I double-sided taped to the frame so the limit switch has something to contact. Seems to work very well.
Any other problems out there?
On the HICTOP metal version, The problem I saw on RepRap forum was the Y plate was installed backwards. the double bearing on the Y rods are suppose to be on the left as view from the front.
Bob