Priusron
Student

I have my SKR 1.4 turbo board. Still waiting for the display. I am attempting to program the WiFi module. I have never had success programming these...

It hits only after the first layer is put down. Instead of the bed dropping, I raises slightly. This is a Corey printer. All the controls work...

I’ll try, thanks. After reset the board resets before it is able to print a file prepared using the Tronxy slicer.It still raises the bed causing the...

I’ll try, thanks

Well I decided to slice the cube in my Tronxy slicer. It gets warm, then starts to move into position. The controller then does a power reset. I then...

Thanks for the reply. I enjoy tinkering and tracking down problem as. That is how I learn. I don’t think any printer is perfect and there are a lot...

The printer has been working great. I have tested the power off restart and it works as it is supposed too. I will be slowing up for a couple weeks...

I had another issue with my filament detector today. After it detected no filament, even with filament going through it, I noticed that when I pushed...

Down at the bottom of the window, change the file type to all files *.* The files on the screen card have to be run through the slicer and...

It won’t allow me to post more that one or two picture

It got finished printing so here are pics of it. Notice the bed height. I added code to my slicers to lower my bed when printing is done. I use the...