printbus
Staff Engineer
Find latest postsMy Social Networking
Mini Statistics
- Join Date
- 05-05-2014
- Last Activity
- 04-06-2021 08:00 AM
- Avatar
Recent Visitors
- Chachin,
- curious aardvark,
- dcsleep,
- Geoff,
- Moccasin,
- mythbu,
- Roberts_Clif,
- terrypin,
- theluanptl,
- trinhlam365
- Tab Content
- printbus's Activity
- Visitor Messages
- About Me
- Friends
-
Older Activity
-
04-06-2021, 08:00 AMYou're correct that the cheat sheet doesn't show all of the parameter options. The cheat sheet, however, is a great tool to have available online...15 replies | 983 view(s)
-
04-05-2021, 03:38 PMI agree with CA that I typically just let the bolt cut it's own threads, but it takes some experimentation to get the printed hole sized right to...26 replies | 1232 view(s)
-
04-05-2021, 03:31 PMYeah, I was going to say the same thing about cylinder vs. linear extrude applied to a circle. I also typically use a $fn for each instance of a...15 replies | 983 view(s)
-
03-25-2021, 06:51 PMIn addition to what CA said, you just extrude a bunch of filament into free air until the old color seems to have been flushed from the hot end.4 replies | 444 view(s)
2 Visitor Messages
About printbus
Basic Information
About printbus
- Location:
- Highlands Ranch, Colorado USA
- Interests:
- Electronics, microcontrollers, RC helicopters
- Occupation:
- Retired
- Thingiverse:
- http://www.thingiverse.com/Printbus/designs
Statistics
Total Posts
- Total Posts
- 1,441
- Posts Per Day
- 0.57
Visitor Messages
- Total Messages
- 2
- Most Recent Message
- 12-15-2015 08:27 AM
General Information
- Last Activity
- 04-06-2021 08:00 AM
- Join Date
- 05-05-2014
What plastic materials can I print?
04-14-2021, 09:59 AM in General 3D Printing Discussion