Qidi Tech 1 - Replicator 1 clone

[wirlybird]

More mythical creatures! 24 hours into a BIG torture test print! This one is taking up almost the full volume of the printer! This is on the QIDI and so far it is performing excellently!!


[IMG][/IMG]

[Talon 3D]

I look forward to seeing the finished form.
You have that dialed in quite well.
What filament are you using?

[wirlybird]

I look forward to seeing the finished form.
You have that dialed in quite well.
What filament are you using?

Makergeeks PLA.

[DaveB]

Makergeeks PLA.

Nuclear Green - Their standard "Maker PLA" is one of my favorite filaments to print with. I have remarkably few issues when printing with it.

[Talon 3D]

Nice!
I am printing with ESun PeTG right now. First print was good except for the screw tab sagged on the SD Card holder model. Now I am working on bed leveling knobs. Been getting about 25% through the print and a glob invariably happens and pulls one or more of the models off the bed. I am going to try and print just one this time.

I did bite the bullet and buy Simplify3D. Liking it so far.

Makergeeks PLA.

[DaveB]

Nice!
I am printing with ESun PeTG right now. First print was good except for the screw tab sagged on the SD Card holder model. Now I am working on bed leveling knobs. Been getting about 25% through the print and a glob invariably happens and pulls one or more of the models off the bed. I am going to try and print just one this time.

I did bite the bullet and buy Simplify3D. Liking it so far.

S3D was a good choice.

[Talon 3D]

I'm thinking so too. Now if I could find good settings for the PetG for it I would be super happy. ABS prints great. PLA not too bad.
PetG just not right.

S3D was a good choice.

[jfkansas]

PetG is a very sticky filament and it doesn't tolerate over extrusion at all. Start at .84 on the multiplier at 250c.

I'm thinking so too. Now if I could find good settings for the PetG for it I would be super happy. ABS prints great. PLA not too bad.
PetG just not right.

[Talon 3D]

I've got the extrusion rate right it seems but not hot enough. I've been at 230c.

PetG is a very sticky filament and it doesn't tolerate over extrusion at all. Start at .84 on the multiplier at 250c.

[Talon 3D]

Sorry it double posted.

I've got the extrusion rate right it seems but not hot enough. I've been at 230c.

PetG is a very sticky filament and it doesn't tolerate over extrusion at all. Start at .84 on the multiplier at 250c.