Hello everyone,

It's my first time here. Hopefully I can contribute and offer help to others as well.

I just upgraded my Rigidbot electronics from a Rigidbot board to an Azteeg X3. So far I'm very impressed by it, but I'm having a software issue. I downloaded the latest version of Marlin and changed a few settings in configuration.h. From what I can see, the X and Y axes are configured the same. Only problem is, the Y axis doesn't work properly. It moves, but not far enough. Moving it 50mm on Repetier Host does not move the bed 50mm. When I try to print something, it comes out squished on the Y axis.

I've tried swapping motors as well as drivers to no avail. To make sure it wasn't just that slot in my board, I tried other slots and switched up the pins.h file. Using various combinations of drivers, motors, and slots, I've found that it only affects anything assigned in pins.h as the Y axis. I have no idea why this is happening.

I've uploaded a zip of the firmware here: Azteeg X3.zip

Thanks in a advance
-Dylan