Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2
  1. 12-08-2014, 08:08 PM #1
    tekati
    tekati is offline
    Student
    Join Date
    Dec 2014
    Posts
    1

    Any ideas what is causing stringyness after the print is already going?

    I had a bad clog that would not clear so I replaced the 0.4mm nozzle and am still getting failed prints.

    Any ideas?

    Failed Print.jpg
    Reply With Quote Reply With Quote
  2. 12-25-2014, 01:58 PM #2
    wackyvorlon
    wackyvorlon is offline
    Student
    Join Date
    Dec 2014
    Posts
    18
    Where do you get your filament from?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules