Hey Guys,

I'm new to this forum so apologizes if this is posted under the wrong form but i have just finished building my first delta 3d printer and have been having some issues with the filament.

it seams like ether the filament is not coming out evenly or it is not sticking to the other layers properly, i have attached a photo bellow. My extrude is 235 degrees and my heat bed is at 110 degrees.

if someone could point me in the right direction that would be great!

10818600_10154859484585585_1781300581_n.jpg10808219_10154859484680585_1507896370_n.jpg