Results 1 to 7 of 7
Threaded View
-
10-14-2014, 06:00 PM #1
printer doesn't print in the center of the bed anymore
I realize this can be set via g-code, but when I place a print at X100mm x Y100mm, it actually prints consistently at about x 120mm, y 120 mm. This happened during/after setting up auto bed leveling. Is there an offset I can reset or perhaps something else stored in eeprom? Thanks.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion