Hello,

When I was trying to remove my filament to swap it, it would not budge, and got stuck.

Eventually it snapped and I have been trying to remove a piece of small, stubborn PLA. I have been printing at 210 degrees. I have tried heating it up, and pulling it out with pliers, which didn't obviously work.

Here's pictures of my problem. And I'm not entirely sure how to disassemble this piece of kit, so if you know how or what model this is, please tell me.

photo 2 (1).jpgphoto 1 (2).jpgphoto 1 (2).jpgphoto 3.jpg