Just got my 3d printer and have run about four objects on it so far. I have had the same issue each time…the piece sticking very, very tightly to the glass bed. The piece sticks so tight that I feel like I am going to break the glass getting it off and have to use a putty knife and a lot of brute force, including banging on the end of the putty knife with my fist, before the piece pops off and shoots across the room . It sticks so hard I'm afraid I might break the glass. I have tried glue, hair spray and blue painters tape with the same result. It is also the same with either PLA or ABS. So, my ultra newbie question is: Is there some trick to getting the piece unstuck that I am unaware of?

Thank you for any help.

Jim
Plastic Scribbler Asterid 2200