platform wont preheat, please help

[malacoda77]

hi all


i just got a powerspec replicator 2 with abs plastic and am using replicatorg with skeinforg 50. when i print from the files that came from the SD card from the factory, it preheats just fine and prints nice. the problem is when i print from replicatorg (sd card or usb, doesn't matter) the platform doesn't preheat.


profile in the printer is set to abs
profile in skeinforge is set to abs
preferences table, the platform temp is set to 110c
script in start.gcode is m109 s110 t0


the only thing that i can see that is wrong is that on the control panel and the status bar in replicatorg, it read "pla extruder temp". i can't find a way to change that.


any ideas? this is driving me crazy.

[old man emu]

Viewing this: https://www.youtube.com/watch?v=fhF-...s&noredirect=1 might give you some help.

Old Man Emu

[3dkarma]

M109 sets the extruder temperature. M190 sets the bed temperature and waits for it to be reached. Is there an M190 or M140 in your G code?