Results 1 to 2 of 2
Thread: Z axix peculiar problem
Threaded View
-
09-13-2014, 08:43 PM #1
Z axix peculiar problem
Hi,
I have built my own prusa i3 a few months ago, It was all set up and printing well. I took a few weeks break from printing to built an enclosure for it.
I have just finished building the enclosure, I have the printer inside the enclosure with my arduino/ ramps board and psu all mounted to the back side of the enclosure.
I have plugged everything back in and checked the wiring, it connected to pronterface fine and I started checking my axis, x moves correct y moves correct then i checked z, it appeared to be correct but then it jammed.
I reset the z so both sides were equal distance and tried again, worked fine then jammed. On closer inspection I realized that my left z axis stepper moved correctly but my right axis stepper motor would spin in 1 direction and then change and spin the other way.
Has anyone encountered this? How can I fix this?
Thanks.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion