Results 1 to 2 of 2
-
07-27-2014, 01:41 PM #1
- Join Date
- Jun 2014
- Posts
- 7
infill is is not filling all the way at 100% fill top is not solid ether
ok so I attached some pic's if you notice in the g-code the perimeter width is .4mm and infill/solid width is .67 this is wrong the infill width is the same as the perimeter width when I measure the two with my digital caliper I thick this is why my infill is not solid and it can't make the top layer solid the other pic is some settings that I think I might need to change to fix this but I not sure what the problem is am I correct about the problem and that the in the g-code it should say that the infill is .4mm
-
07-28-2014, 04:01 PM #2
- Join Date
- Jan 2014
- Posts
- 462
Your extrusion multiplier is extremely low at 0.81 - meaning you're under-extruding. Try upping it.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion