Results 1 to 3 of 3
Thread: Ender 3 Pro Problems
-
06-21-2020, 08:34 AM #1
- Join Date
- Jun 2020
- Posts
- 2
Ender 3 Pro Problems PLEASE HELP
I am new to 3D printing and just sat up my new Ender. The problem that i am having is the prints keep going off to the right of the bed. The X Y Z are flashing and it says 0 next to them. What am i doing wrong?
Last edited by ortizzzel; 06-21-2020 at 09:36 AM.
-
06-21-2020, 09:35 AM #2
- Join Date
- Jun 2020
- Posts
- 2
Also, just attempted to do another print and it is suppose to be printing at 50.2 X 37.5 X 42.0 mm and it is printing extremely wide and thin and going to 123 X, 139 Y. It's making a weird noise and I'm not sure what is going wrong.
-
06-21-2020, 04:29 PM #3
- Join Date
- May 2020
- Location
- Swindon, England
- Posts
- 7
Is it the very first print? It sounds like something isn't set up correctly in the firmware, or possibly you've got a cable connected wrongly (less likely). where does the auto-homing go to?
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion