Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2

Threaded View

  1. 04-06-2020, 08:23 PM #1
    crabjoe
    crabjoe is offline
    Student
    Join Date
    Mar 2020
    Location
    Ceciltucky
    Posts
    12

    Help Plz - Tronxy X5SA Pro - The need for speed!

    So I printed this calibration cube and it took 40 mins! It's only a 2cm cube that Cura estimated would take 18 mins.What's in the world is going on? Below is a pic of the recommended settings and the cube..

    What settings should I be looking at to change this? Or is it a problem that I need to change in the firmware?


    cali_cube_setting_cura.JPG


    cali_cube_pix.jpg

    40mins.JPG
    Last edited by crabjoe; 04-06-2020 at 08:39 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules