I need some help with this one as I have tried multiple settings and cant get this one figured out. Attached is a phone where the layers "look" to be spearating in some spots. I cannot tell if this is from under extrusion or cooling or what. I have tried turning the temp up to 210C. I have tried turning the heat bed up to keep material warmer (70C) I have set the extrusion to 105% I have decreased the cooling fan speed to 80% The material is Craft PLA Filament with 195-215 recommended temp. I have not gone to 215 yet.

Any advise would be greatly appreciated. I do not have this issue with my Hatchbox PLA so it might just be the material but I cannot find this color material from another vendor.

https://www.dropbox.com/s/lq04gs42qb...20AM.jpeg?dl=0