I purchased a used delta that's supposedly a Micromake "clone", or so the guy said.


I have had a cartesian (Tevo Tarantula) for about 6 months now and have it mastered. I am a total noob when it comes to deltas however, and this one is giving me fits. I've had it for 2 weeks and have had nothing but 100% fails on every print and I don't know why. I've literally taken it completely apart and re-assembled it numerous times and it still weirds out on me. Everything is as it should be physically. Nothing is too tight/loose or out of alignment.


It'll all of a sudden go off on its own path and start extruding filament everywhere but where it's supposed to and I can not track down the problem or reason why.


I do have the correct firmware installed, and as far as I know, the correct settings where they need to be in the configuration.h script.


I am at a loss. Any help/suggestions/advice will be greatly appreciated.