Subscribe to Our Newsletter Advertise
Close



Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11
  1. 09-13-2017, 06:36 AM #11
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,142
    Add Roberts_Clif on Thingiverse
    I re-designed a Fan Duct for my 3D Printer, decided on a Half Circle as I could easily reach the oozing filament for removal.
    I included a duct to the throat Heat sink to cool it. As the stock design of no cooling system kept melting the PTFE lining in the throats.

    I liked watching the video showing that a similar design had worked well.

    HalfCircle.jpg
    Last edited by Roberts_Clif; 09-13-2017 at 06:50 AM.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules