Hi!

I just finished building my Anet A8 printer. The first print worked fine, I set it to "cooldown", then unplugged it after a few mins. Now, a few hours later, it will no longer print. Both temps say "def".

I have:
Soldered the heatbed wires on the heatbed
Re-soldered the thermistor on the heatbed

The ohms are as follows: Extruder; 110-120k ohm
Heatbed: 55-59k ohm
(unconnected)

When the heatbed is connected to the mobo, it measures 5.7k ohm. The extruder measures 16-17ohm when connected.

Any suggestions?

Cheers