Close



Page 9 of 9 FirstFirst ... 789
Results 81 to 87 of 87
  1. #81
    Okay then, guess I will print out the manually level knobs and make it so the bed is 90 to the towers on all 3 sides, once my PETG arrives >.>

  2. #82
    Or, better yet, loosen up the corner brackets and shift the vertical towers around to get it plumbed up.

  3. #83
    well it's not too far off, more like 89 degrees or 88 possibly.

  4. #84
    Not horrible, but could be better.

  5. #85
    Since you are online, did you copy the Config and Config.adv when upgrading to the latest Marlin version?

  6. #86
    I did from the 1.1.4 version to 1.1.5. Here's the weird thing. I went back to 1.1.4 again, and did the same thing, the results seem to be better in 1.1.4 than in 1.1.5, however still not leveled, but better after G33 P7. However, I feel like the G29 I did isn't being applied, because i checked the movement of the nozzle before G29 and again after G29 with M420 S1, there is no difference. So I'm at a loss here. Tested using Bilinear haven't had time to try UBL yet.

  7. #87
    Okay so a new video came out, and it looks like I'm not the only one with this problem, it seems to be just the Linear Rails version. Here's the vid. https://www.youtube.com/watch?v=-e3UXj5ly3U According to him, the machines rods might not be all the same, and according to one of the comments, the reason for me getting higher points values at one point seems to be the effector tilting at certain points on the bed, causing it to suddenly go higher (which is exactly the problem I have) and therefore G29 or such isn't able to compensate for that. Am going o try EZbed, but it looks like manual knob leveling (I know I've said it multiple times, but now I'm almost 100% certain I need to go that way) really is the way to go. Any good knob leveling? I'm using the one provided by Homofaciens who did something similar on his Anycubic kossel but the pulley version.

Page 9 of 9 FirstFirst ... 789

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •