Close



Results 1 to 3 of 3
  1. #1

    Filament coming out in preheat and during a print when it's not supposed to

    Every time the nozzle is heated PLA filament leaks out, even during a print when it's going over something it's not supposed to print. This has happened since I got my QIDI X-One a couple days ago. I have been told to just "grab it with a pliers" but that's not practical during the print. I am new to printing so I might need to adjust something on the printer.

    Here is a print where the extruder has to go back and forth between two columns, leaving filament suspended in the print.
    https://photos.app.goo.gl/wqSMzDqfrIQGW2on2

  2. #2
    Engineer-in-Training
    Join Date
    Jun 2017
    Posts
    280
    During the warm-up is normal. The other times, you need to adjust the retraction settings. What slicer are you using?

  3. #3
    I am using Cura.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •