Hello everyone, below I have a picture of two PLA prints that use the exact same settings and slicer, speed at 30mm/s, 186C. The one on the left came out nearly perfect, the next part I printed, the one on the right came out absolutely terrible and has very poor layer adhesion. I have a Hictop i3 clone with the z axis mod to prevent wobble. I am a bit lost as to what the problem could be but I think it may be an extruder stepper motor issue? I have tried to research this problem but can not find anything like it. Also had an x wobble that would appear in Cura but would be fine in Slic3r with the same print speed. Not sure if these are related but I am now lost as to what step to take next.


printer issue.jpg