Results 1 to 10 of 474
Threaded View
-
11-28-2017, 04:10 PM #11
- Join Date
- Jul 2017
- Posts
- 193
No, I did not buy any auto calibration SW.
So on the Dev 1.0 level, there are multiple fixes to the distortion correction function. The way I understand it to work (once enabled ) is you use the bed height map tool ( in repetier-host tools) and that maps the distortion on the bed. Once completed, you save it in the EEPROM with a G command ( which is not currently our firmware. Then the firmware will automatically correct for the delta z for about the first 1 mm of layer height. see https://www.youtube.com/watch?v=L9URtv2LqKc
Here is the configuration utility words on it.
Capture.jpg
Ender 3 Neo - Jam Problem
Today, 12:39 PM in Tips, Tricks and Tech Help