Quote Originally Posted by curious aardvark View Post
yeah uds - ugly drum smoker. Good cookers.


So on the 1.0 does it actually do an auto calbration ? Or is it the same nonsense with the numbers thing, that doesn't actually work ?

Didn't you buy the auto calibration software ? or was that someone else ?
No, I did not buy any auto calibration SW.

So on the Dev 1.0 level, there are multiple fixes to the distortion correction function. The way I understand it to work (once enabled ) is you use the bed height map tool ( in repetier-host tools) and that maps the distortion on the bed. Once completed, you save it in the EEPROM with a G command ( which is not currently our firmware. Then the firmware will automatically correct for the delta z for about the first 1 mm of layer height. see https://www.youtube.com/watch?v=L9URtv2LqKc

Here is the configuration utility words on it.
Capture.jpg