Hi! I've been recently building a 3D printer and I'm having issues testing it.This is my hardware:
Ramps1.4
Arduino mega2560
4x Pololu Motor shields a4988
1x Nema17 extruder
2x floppy stepper motor
1x DVD stepper motor
Generic hotend with 0,4 nozzle
Then I assembled everything and I started testing... I tried ramps test code and it didn't work (motors did not move, but I'm sure they are ok), then I tried using marlin and pronterface; it showed hotend temperature stuck at 150 degrees, but the hotend was not hot. Moreover motors would not move.
I also tried repetier host and it returned me a m999 error without any further explanation.
I had no problem installing firmwares on the arduino and the fan of the hotend is working. I also tried changing baud rate but it seemed not to work.
I need a quick help since this is a school project I need to have a working printer before next week (13 days max). I'm asking for a fast solution to this problem.
Thank you in advance and sorry for my bad English.